This special edition, fully stepped and repeatable equalizer is ready for all duties including mix buss and mastering applications where precise control is required. Hand built in the USA this boutique manufacturer of solid outboard hardware steps into the high end with this Baxandall design with added midrange control and low cut filters. Just look at the full control you have over the entire frequency spectrum, and the fine repeatable steps available!
Highlights
- 100% recallability with stepped controls throughout
- Extremely clean and transparent audio path
- Extremely low noise floor
- Perfect for tone shaping without changing the sonic character of source audio
Specifications
- ​High, Mid, and Low Boost/Cut amounts:
+/- 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 5, 6, and 8 dB - Six High Frequency Selections:
9kHz, 13kHz, 16kHz, 20kHz, 27kHz, and 40kHz - Six Mid Frequency Selections:
200Hz, 400Hz, 800Hz, 2kHz, 4kHz, and 7kHz - Six Low Frequency Selections:
20Hz, 30Hz, 40Hz, 60Hz, 85Hz, and 120Hz - Four Position Low-Cut Filter @ 6dB/octave:
Off, 10Hz, 20Hz, and 40Hz - Input Impedance: greater than 10k ohms
- Output Impedance: less than 50 ohms
- Noise Floor: below -90dBu
- Input AC: 110V-120V
Build Materials​
- 4mm thick anodize aluminum front panel with black infill engravings
- 2mm thick aluminum rear panel with non-filled engravings
- All aluminum chassis
- ELMA 24 position rotary switches for Boost/Cut controls
- 6 position rotary switches for Frequency Selectors
- 4 button push bank for Low Cut Filter
- WIMA film capacitors
- Low ESR Panasonic FC Electrolytic capacitors
- Metal Film Resistors
- High Speed LME49710 opamps
- C0G NP0 ceramic capacitors
Our ONE WITH EVERYTHING ZEN WARRANTY extends the standard manufacturer warranty by one year, see our ZEN WARRANTY page for details.
