The first Neumann mic with transformerless technology, featuring 5 directional characteristics, selectable at the mic or remotely, in addition to pre-attenuation and low-cut filter switches. The excellent sound pressure handling capability makes this mic ideal for recording wind instruments, for example.
The TLM 170 R was the first microphone to use the successful fet 100 technology. Along with a balanced, transformerless output stage it features extremely low self-noise and an impressive dynamic range.
Five directional characteristics are selectable by means of a rotary switch. In the sixth position, marked "R", the directional patterns can be controlled remotely with the N 248 power supply. There is no special cable necessary for this purpose.
The microphone has at its rear a 10 dB attenuation switch for extremely high sound pressure levels, and a high-pass filter to suppress structure born noise.
Neumann TLM 170 R Features
- Local and remote controlled large diaphragm microphone
- Pressure-gradient transducer with double membrane capsule
- Five directional characteristics: omni, wide angle cardioid, cardioid, hypercardioid, figure-8
- Patented circuitry for remote and local switching of directional characteristics
- Switchable low frequency roll-off and 10 dB preattenuation
- Tiltable, elastically suspended bracket mount
Neumann TLM 170 R Specifications
- Acoustical operating principle Pressure gradient transducer
- Directional pattern Omnidirectional, wide angle cardioid, cardioid, hypercardioid, figure-8
- Frequency range 20 Hz ... 20 kHz
- Sensitivity at 1 kHz into 1 kohm 8 mV/Pa
- Rated impedance 50 ohms
- Rated load impedance 1 kohms
- Equivalent noise level, CCIR1) 26 dB
- Equivalent noise level, A-weighted1) 14 dB-A
- Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL) 68 dB
- Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL) 80 dB
- Maximum SPL for THD 0.5%2) 144 dB
- Maximum SPL for THD 0.5% with preattenuation2) 154 dB
- Maximum output voltage 10 dBu
- Dynamic range of the microphone amplifier (A-weighted) 130 dB
- Supply voltage (P48, IEC 61938) 48 V ± 4 V
- Current consumption (P48, IEC 61938) 3 mA
- Matching connector XLR3F
- Weight 625 g
- Diameter 60 mm
- Length 152 mm
Neumann TLM 170 R Accessories
- Windscreen WS 87
- Elastic Suspension EA 170 (mt)
- Double Mount DS 120